Incredible
240 degrees x 130 degrees Pan 'n Tilt Range -Now you can easily control remotely what your camera is looking
at; Pan 240 degrees left to right (31 seconds per cycle) and tilt
130 degrees up and down! (15 seconds per cycle). Amazingly smooth & fluid movement!
ROBOCAM
ScanPad Remote (Included) - Use the ROBOCAM
Remote to
scan between 4 cameras (on/off) and control the position of each
camera that is mounted on a ROBOCAM Pan 'n Tilt base. Remote sends
RF (Radio Frequency) signals to
X10 Transceiver, which passes the signals through your house
wiring to control the cameras.
PLEASE NOTE, to turn cameras on/off using the ScanPad remote you additionaly need
a TM13U X10 transceiver which is an optional extra, listed below.
 Ultra Sweep
& Scan Feature™ - Put
your ROBOCAM on Auto-Pilot! You
can store up to 4 positions for each camera. Then using the
"sweep" button on your ROBOCAM
ScanPad, you can
automatically sweep thru the 4 stored positions (ex. front
driveway, street, front lawn, and front door area.) Great for
recording and monitoring an entire 240 degree area when you're not home!
|
The ROBOCAM ScanPad Remote:
Scan between all your cameras
using the C1 - C4 buttons. Use
the "blue" arrow buttons to pan
the selected camera left/right or
tilt up/down. Using the P1-P4
buttons set 4 separate locations
to monitor. Then by selecting the
"sweep" button, ROBOCAM will
automatically move to each
position then repeat
Note: The ROBOCAM Unit itself can pan 180 degrees and
tilt 70 degrees. When you add a camera, you gain an
additional 60 degrees of viewable area! Thus, your
viewable range is 240 degrees by 130 degrees
|
Approved
