Friday, 10th September 2010

Xantech 291-10DB Hidden Link Designer Infra-Red Receiver

The 291 series are small, shelf-top IR receivers with a multitude of applications. Use them as an inexpensive method of repeating IR commands when wall-mounting an IR receiver is not practical. As with all Xantech IR receivers, the 291 can tie into multiroom IR extension systems.

This infra-red receiver is wired to the included CB12 or to other IR Connecting Blocks. Then infra-red emitter(s) are plugged into the Block and attached to the equipment you want to control.

The 291-10 is terminated in a 3.5mm plug for + / - / signal, and require a 9v or 12V REGULATED DC power source (Do NOT use unregulated adaptors). Power is applied via the Block.

You would normally use these products to control devices that are out of sight (in a cupboard for instance), for hardwiring infra-red distribution around the house, or for sending commands back to a home controller, like HomeVision.

Note. Includes CB12 Block. Does not include emitters or 12V power supply

FEATURES

Attractive case for shelf-top locations
Red talkback LED tests system for correct wiring as well as indicating infrared reception
Nominal reception angle: 45 degrees off axis
Attached 7' cable and 3.5 mm stereo mini plug permits direct plug-in to Xantech Connecting Blocks that have an "IR RCVR" or "AUX" jack, such as the CB12, CB20, CB60, 789-44, 791-44, etc
Cable requirements for long lengths: Three-conductor/24 gauge up to 200', 22 gauge up to 600', 20 gauge up to 2000' and 18 gauge up to 5000' (unshielded OK)
Maximum cable length: One mile with 18 gauge
Maximum current output: 100 milliamps
Power: 12 volts DC @ 10 milliamps
Includes a CB12 Connecting Block