Thursday, 23rdFebruary 2012
|
|
 |
ebode RMV Motor Drive Wall Switch
Install a RMV (our part No 12844) to control your projector screen. The RMV
is designed for
controlling screens that move up and down, or shutters that move left and
right.
Remove your existing switch and replace it with the RMV. The RMV has inputs
for Positive, and Neutral, and outputs for "up" and "down". These should
correspond with the wires you already have at the old switch.
It should be noted that the RMV is an analogue device that uses approximate
timings for the open and close duration. Therefore it is neccasary to set
the screen's lower limiter to stop the screen where you actually want it.
To do this you should wind the screen up, adjust the down travel limiter by
half a turn, drop the screen and check where it stops, raise the screen
again, adjust by half a turn, drop the screen and check - repeat until happy
with setting, don't make more than half a turn adjustment at a time etc and
don't adjust the down limiter without having retracted the screen fully
first
Whilst the RMV is a European shaped module, it will fit into a 47mm UK
backbox
 Approved
|
Part No |
Description |
Stock Availability at 01:41 Feb, 23 |
If ordered on-line Price = |
Qty to
order |
|
