Saturday, 16th February 2019

Home >> Xantech >> Xantech 283D Designer Single Blink Infra-Red Emitters

Connect these emitters up to a IR splitter block, or directly to a home controller like HomeVision, and use them to send infra-red signals to any infra-red controlled device, like a TV, VCR, Hi-Fi, etc.

The Xantech branded emitters, have infra-red output, and a visible blinking LED facing away from the equipment. This allows visible confirmation of infra-red commands being sent.

Normal installation is via IR splitter block, then each emitter is placed directly over your equipment's IR "eye". An IR receiver may also be added which will allow you hide your equipment out of sight whilst still allowing infra-red control.

Example complete setup with IR Receiver, Splitter Block, PSU and emitters:


28DES Mouse Shield Cover for DESIGNER emitters. Stops stray infra-red getting to device. Only for use 282D, 283D, 283DMW, 284D, 286D Xantech Designer Emitters	12489 Black Wire "Dressing" (Hides Emitter Wire nicely blending into component's case	12490 Silver Wire "Dressing" (Hides Emitter Wire nicely blending into component's case